SoftMaker.com

English-Language Support
It is currently Tue Jun 18, 2013 5:59 am

View unanswered posts | View active topics


Board index » SoftMaker Office 2010 for Windows » BasicMaker 2010 for Windows

All times are UTC + 1 hour




Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Previous topic | Next topic 
Author Message
Ananda
 Post subject: Porting VBA macros...
PostPosted: Sat May 29, 2010 1:57 am 
Offline

Joined: Sat May 29, 2010 1:52 am
Posts: 1
Dear Friends,

For many years I was using MS Word and over that time have written many thousands of lines of code in VBA. I was wondering if there is any easy way of porting these to BasicMaker? The thought of doing it all by hand is daunting to say the least.
Top
 Profile  
 
sven-l
PostPosted: Mon May 31, 2010 7:36 am 
Offline
SoftMaker Team
SoftMaker Team

Joined: Wed Apr 09, 2008 7:26 am
Posts: 4578
Location: Nuremberg
Hello,
the only way is currently to copy&paste the code into a new BasicMaker file and to adjust the code. Fur further help you can use the BasicMaker manual.

_________________
Sven Leßmann
SoftMaker Software GmbH
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » SoftMaker Office 2010 for Windows » BasicMaker 2010 for Windows

All times are UTC + 1 hour


Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group